Dot Hill Systems SANnet II 200 Specifiche Scaricare il pdf (Pagina 13)

Termination Module

The SANnet II 200 SCSI array terminator board is a field-serviceable FRU that supplies the SCSI

termination throughout a base enclosure. It is hot-serviceable but not hot-swappable, so replacing

one will require planned downtime. The termination module is essentially hidden between

controllers, so it requires the removal of controllers before it can be replaced.

To remove a termination module, first remove all controllers and then remove the termination

module by pulling it out from the enclosure. In configurations with single controllers, you must

remove the blank controller panel as well as the controller. To install a termination module, slide

it into the enclosure until it stops. Reinstall the controllers when done. There is no termination

module within expansion enclosures.

FIGURE 10: Termination Module

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 34 35

Nessun commento

Dot Hill Systems SANnet II 200 Specifiche Pagina 13